Installation Instructions:

• Surface must be clean and dry.

• Remove ALL wax and contaminants. Clean a 4’ wide x 8’ long rectangle on hull with Isopropyl Alcohol – use eye protection.

• Apply XtraLook XTS baits following Bait School Diagram (below), exact placement of baits not required. Large, Medium and Small baits give depth to the bait’s appearance. Arrange your bait school in the shape of a teardrop with the point of the teardrop toward stern. Center the bait school between the waterline on bow when trolling, and transom.

• Peel bait from backing. Be sure head of fish is toward bow of boat. Apply gently at first. Adhesive on bait is pressure sensitive. You can adjust them, just pull off and re-apply. Press firmly once positioned. Wait 72 hours before boating. Do not apply when temperature is below 50° F, 10°C.

• Installation Tip - Flying Fish and Squid:
Before you get started, remove the excess material from around all the baits. Peel back the head only and apply it first, then roll the backing away from the bait as you slide your thumb/forefinger down over the bait. 

• Stencil Instructions - XtraLook XTS - Ablative Painted Hulls:
Remove fish decal from backing and discard. Apply the fish outline decal per the bait school diagram below. Paint with contrasting color using a 1”chip brush. Remove fish outline decal before paint dries for a smoother edge.

• 6-Year Vinyl, Waterproof Adhesive.

• Durable – Water Pressure Tested to 1,750 psi

• No Special Care Necessary.

• XtraLook XTS adheres to Fiberglass, Painted, and Aluminum Boat Hulls.

• Not recommended for ablative paints

Installation Questions? click here.
Ready to Purchase? click here

Thank you for using XtraLook!

Angler of the Week:

Capt. Joe Verdino (right) with a 93lb. Amberjack caught using Xtralook XTS-11 Ballyhoo.